BM45 - BM65: STEP 3

We show you how to mount a 1’’ multi-stack tooling on a BM45 and a 1’’ ¼ multi-stack tooling on a BM65.

Hi! I’m Stefano from Italy. Thanks for watching our Pedrazzoli video tutorials. In these videos we show you how to mount a 1’’ multi-stack tooling on a BM45 and a 1’’ ¼ multi-stack tooling on a BM65.

To fix the mandrel rod we have two possibilities: if you fix the rod like this, it is not possible and the rod will not rotate; if you fix the rod like this, the rod will rotate with the mandrel.

How to insert the collet in the carriage.

The pressure die is equipped with nuts and screws that regulate the height. The height is already regulated by the factory. If for any reason you have to aligne the pressure die, you just unlock the nut and with the key you can lift it up and down.

From here, by screwing or unscrewing, you can regulate the height of the tool. 

The same is applied on here: you can regulate the height of the hole block and you can regulate just the height of the roll from here.

 

 

 

 

 

 

Don’t esitate to contact your commercial partner for all the questions or doubts.